Kyocera KM-C830 Quick Start Manual page 8

Step 6 Continued
3. For Recipient 1 Address, enter an Internet e-mail address; preferably one that can easily be
connected to for delivery verification.
4. Under Event Reports, click the Cover Open checkbox.
5. For E-mail Interval, enter 1 minute.
6. Click Submit.
The IB-21e version 1.33 or later has the "send" button on this page to send an email for testing.
Customer Site – Verify E-mail Delivery
7. Open one of the printer's covers. Wait a couple minutes and then check your Internet e-mail
account to see if it received the error report e-mail.
If it did, then the customer's mail server is set to allow POP3 clients to send to the Internet and
the printer's e-mail reports should be able to be received by the ServiceGateway.
When finished, be sure to eliminate these test settings made to the E-mail Recipient 1
page.
If the test error report e-mail is not received, then most likely the customer's mail server
configuration needs to be modified.
Note: There is a "send" button for sending test e-mail reports in IB-21E version 1.3.0 or higher.
Step 7
Customer Site – Mail Server Modifications
If the test e-mail in the previous section was successful, then no modifications to the mail server are
necessary and you may proceed to Step 8.
Figure 5. E-mail Recipient for Internet E-mail Verification
8
KM-Net Service Gateway