Installation - LG LAC-M4510R Owner's Manual

Basic Installation
Before installing, make sure that the ignition-switch is set to OFF and remove
the car battery terminal to avoid short-circuiting.
1. Remove the existing receiver unit.
2. Make the necessary connections.
3. Install the mounting sleeve.
4. Install the unit in to the mounting sleeve.
Removing existing receiver unit
If there already is a mounting sleeve for the receiver unit in the
dashboard, it must be removed.
When removing the unit from the mounting sleeve
If you need to remove the unit from the mounting sleeve, proceed as follows.
1. Remove the rear support from the unit.
2. Remove the front panel and trim ring from the unit.
3. Insert the lever into the hole on one side of the unit. Perform the same
A
operation on the other side and pull the unit out from the mounting sleeve.
ISO-DIN Installation
1. Slide the unit into ISO-DIN frame.
2. Install screws removed from old unit.
3. Slide the unit and frame into the dash opening.
4. Mount the dash panel or adapter plate.
5. Mount the trim ring onto the unit.
6. Install the faceplate by sliding the right edge into position and then pushing
the left edge closed.

Installation

Bend the claws
according to
the thickness
of the
dashboard
A
A
3
4
5
6
1
2
7