Installation - LG LAC6700RP Owner's Manual

Battery Installation

Installation

Basic Installation
Bend the claws
according to
the thickness
of the
dashboard
Control panel
Removing the existing receiver unit
A
A
ISO-DIN Installation
4
3
5
6
Control panel
1 Remove the battery holder with a sharp product
like a ball point pen.
2 Install the battery on the battery holder.
3 Install the battery holder back into its original
position.
Note
• Use only one CR2025 (3V) lithium battery.
• Remove the battery if the remote control is not
used for a long period of time.
• Do not leave the product in a hot or humid place.
• Do not handle the battery with metallic tools.
• Do not store the battery with metallic materials.
Before installing, make sure that the ignition-switch is set to
OFF and remove the terminal of the car battery to avoid
short-circuiting.
1 Remove the existing receiver unit.
2 Make the necessary connections.
3 Install the installation sleeve.
4 Install the unit into the installation sleeve.
If there is already an installation sleeve for the receiver unit
in the dashboard, it must be removed.
1 Remove the rear support from the unit.
2 Remove the control panel and trim ring from the unit.
3 Insert the lever A into the hole on one side of the unit.
Perform the same operation on the other side and pull
the unit out from the mounting sleeve.
1 Slide the unit into the ISO-DIN frame.
2 Fit screws removed from the old unit.
3 Slide the unit and frame into the dash opening.
4 Install the dash panel or adapter plate.
1
5 Install the trim ring to the unit.
6 Install the control panel to the unit.
2
6