Table of Contents
Advertisement
Installation
Basic Installation
Before installing, make sure that the
Bend the claws
ignition-switch is set to OFF and
according to
the thickness
remove the terminal of the car battery
of the
to avoid short-circuiting.
dashboard
1
2
3
4
Control panel
Removing the existing receiver unit
If there is already an installation
sleeve for the receiver unit in the
A
dashboard, it must be removed.
1
2
A
3
6
CAR CD/MP3/WMA Receiver
ISO-DIN Installation
Remove the existing receiver unit.
Make the necessary connections.
6
Install the installation sleeve.
Install the unit into the installation
sleeve.
Control panel
Remove the rear support from the
unit.
Remove the control panel and trim
ring from the unit.
Insert the lever A into the hole on
one side of the unit.
Perform the same operation on
the other side and pull the unit out
from the mounting sleeve.
1
Slide the unit into the ISO-DIN
frame.
2
Fit screws removed from the old
unit.
1
3
Slide the unit and frame into the
4
3
dash opening.
5
4
Install the dash panel or adapter
2
plate.
5
Install the trim ring to the unit.
6
Install the control panel to the unit.
Advertisement
Table of Contents
