Table of Contents
Advertisement
Installation
Bend the claws
according to
the thickness
of the
dashboard
Front panel
A
A
4
3
5
6
Front panel
Basic Installation
Before installing, make sure that the ignition-switch is set to
OFF and remove the terminal of the car battery to avoid
short-circuiting.
1 Remove the existing receiver unit.
2 Make the necessary connections.
3 Install the installation sleeve.
4 Install the unit into the installation sleeve.
Removing the existing receiver unit.
If there is already an installation sleeve for the receiver unit in
the dashboard, it must be removed.
1 Remove the rear support from the unit.
2 Remove the front panel and trim ring from the unit.
3 Insert the lever A into the hole on one side of the unit.
Perform the same operation on the other side and pull the
unit out from the mounting sleeve.
ISO-DIN Installation
1 Slide the unit into the ISO-DIN frame.
2 Install screws removed from the old unit.
3 Slide the unit and frame into dash opening.
4 Install the dash panel or adapter plate.
1
5 Install the trim ring to unit.
6 Install the faceplate by fitting right edge into position then
2
pushing left edge closed.
8
Advertisement
Table of Contents
