Default Gateway - Kyocera Mita FS-1128MFP Setup Manual

Panel Setup
1
2
3
4
1
2
1
2
3
4
1
2
3
4
14

Default Gateway

In the IPv4 Setting menu, press
Press [OK]. The Default Gateway screen appears.
Use the arrow keys to set the default gateway.
Press and to increase or decrease, respectively, the value at the blinking
cursor. You can set any value between 000 and 255.
Use and to move the cursor right and left.
Press [OK]. The default gateway is stored and the IPv4 Setting menu reappears.
IPv6 Setting (TCP/IP IPv6 settings)
This selects the settings for TCP/IP (IPv6).
In the TCP/IP Setting menu, press
Press [OK]. The IPv6 Setting menu screen appears.
The options available in the TCP/IP (IPv6) settings are as follows:
• TCP/IP(IPv6) (Enable/disable TCP/IP (IPv6))
• Prefix Length (Prefix Length setting)
• RA(Stateless) (RA (Stateless) setting)
• DHCPv6 (DHCPv6 setting)
TCP/IP(IPv6)
In the IPv6 Setting menu, press
Press [OK]. The TCP/IP(IPv6) screen appears.
Press or to select whether TCP/IP (IPv6) is enabled.
Press [OK]. The TCP/IP(IPv6) is set and the IPv6 Setting menu reappears.
Prefix Length
In the IPv6 Setting menu, press
Press [OK]. The Prefix Length screen appears.
Use the arrow keys to set the default gateway.
Press or to increase or decrease, respectively, the value at the blinking cursor.
You can set any value between 0 and 128.
Use and to move the cursor right and left.
Press [OK]. The Prefix Length is set and the IPv6 Setting menu reappears.
or to select Default Gateway.
or to select IPv6 Setting.
or to select TCP/IP(IPv6).
or to select Prefix Length.
SETUP GUIDE