Errors
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Residual water is present in
the compartment
Vibrations and movement of
the appliance whilst spinning.
Drum does not turn, water
does not flow in.
Heavy foam build-up
Noise
Errors
Rushing, hissing noise.
Cause
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Insert in compartment
.
blocked.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been re-
moved.
Load detection is active.
Detergent dosage is too high.
Cause
Water is flushed under pres-
sure into the detergent
drawer.
Troubleshooting
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry to-
gether in the drum. Different sized items
of laundry distribute themselves better
during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Not a fault – no action required.
▶
→ "Cleaning the detergent drawer",
is
▶
Page 45
→ "Aligning the appliance", Page 16
▶
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
→ "Removing the transit bolts",
▶
Page 14
Not a fault – no action required.
▶
Note: The load detection can take up to
two minutes.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the same
load.
Troubleshooting
Not a fault – normal operating noise.
▶
Troubleshooting en
55