Bennett Marine BOLT Installation & User Manual page 36

Troubleshooting
not flashing, then there is no
communication between the
display and the relay module.
Check the connector on the
communications cable
» If the red LED on the top
center of the BCI relay
module flashes dimly ever 3-5
seconds, then the power to
the orange wire on the display
is not connected
» Verify that the power source
to the orange wire on the
display is turned ON. If this
power is through the ignition,
the ignition must be ON
» If the red LED on the top
center of the BCI relay
module is completely off, then
there is no power to the BCI
relay module
» Check fuse on orange wire
to the BCI relay module.
(Fuse should be 20A for 12V
systems and 10A for 24V
systems).
» Check for voltage from the
system being supplied to the
orange wire. Use a volt-Ohm
meter to check black ground
wire on system to insure it is
connected to the ground buss
bar.
» Check that the green
36
continued
• Problem: One tab moves and one
does not.
Bennett Marine | Bolt Electric Trim Tab System
communications LED in the
top left corner of the BCI is
flashing.
» If the green LED is not
flashing, then there is no
communications between the
display and the relay module.
» Check to insure the display
is connected at the relay
module.
» If a display extension cable is
used, check the connections
at the relay module and at the
display.
» If the red power LED is
illuminated and the green
power LED is flashing and
the system is still not working,
please contact Bennett Marine
Client Services.
» On the actuator that is not
moving, disconnect the
actuator from the harness.
Remove the orange wedge-
lock from the connector
and inspect the connector
contacts. The contact must
be seated evenly and all the
way up to the end of the
connector for the mating pins
to make contact. Push the
wires up into the connector