Table of Contents
Advertisement
The BOLT Electric Trim Tab system
is built with the same rigid quality
standards as all of the other Bennett
product lines. Bennett stands behind
its products, providing exceptional
customer service and support.
Please feel free to call Bennett for
assistance in troubleshooting your
particular issue.
Troubleshooting Systems
with Rocker Switch
Controls (BRC4000)
• Problem: Both tabs not moving.
» Check that batteries are
turned on and charged
» Check fuse on orange wire
to the rocker switch. (Fuse
should be 20A for 12V
systems and 10A for 24V
systems)
» Check black ground wire
on system to insure it is
connected to the ground
buss bar
» Check for voltage from the
system being supplied to the
orange wire use a volt-Ohm
meter to check this
Bennett Marine | Bolt Electric Trim Tab System
Troubleshooting
• Problem: One tab moves and one
does not.
» On the actuator that is not
moving, disconnect the
actuator from the harness.
Remove the orange wedge-
lock from the connector
using a small flat screwdriver.
Inspect the connector
contacts. The contact must
be seated evenly and all the
way up to the end of the
connector for the mating pins
to make contact. Push the
wires up into the connector
until the contacts snap in
place. Replace the orange
wedge-lock, reconnect the
actuator to the extension cable
and re-test.
• Problem: Actuator extends when
BOW UP Button is pressed and
actuator retracts when BOW
DOWN is pressed.
» The actuator wires are reversed
in the connector. Disconnect
the actuator that is not
moving properly. Remove
the orange wedge-lock from
the connector. Remove the
contacts from the connector
using a small straight blade
screw driver to release the
internal snaps. Re-insert
the actuator wires into the
connector in the reverse order.
Re-insert the orange wedge-
33
Advertisement
Table of Contents
