Table of Contents
Advertisement
Installing the Trim Tabs
If your set came with adjustable upper hinge actuators (BEA3000), follow the
"Installing the Trim Tabs" instructions in this section, until instructed to skip ahead.
Position the tab: Using the backing plate, choose a location 3-4" from the chine
(see figure 1 on page 10). Maintain a minimum of 8" from the centerline of your
drive unit to the closest edge of the trim tab. Align the bottom of the backing plate
as per figure 2. The hole pattern on the backing plate should be closer to the
bottom edge of the backing plate.
Figure 2
Mount the
backing plate
1/8" to 1/4" from
the hull bottom
• Mark the pilot holes using the backing plate as a template. Make sure the tabs
can be mounted in the same location on both sides.
Verify that there are no mounting restrictions inside or outside the transom.
• Drill the mounting plate holes, using a 5/32" drill bit.
Bennett Marine | Bolt Electric Trim Tab System
Actuator & Tab Installation
continued
Fixed upper hinge is flexible
to accomodate varying transom angles
1/8"
Straight Edge
1/2" for
5/8" for
9" Chord
12" Chord
11
Advertisement
Table of Contents
