Table of Contents
Advertisement
Helm Control Installation
BCN BOLT Control (BCN6000)
See wiring diagrams and installation templates
starting on page 24.
• Before drilling any holes, read the
entire instructions. Before performing any electrical
work on a vessel, disconnect the battery by
removing the positive (+) cable or if equipped, turn
the battery disconnect switch to the OFF position.
• Using the included template (Pg. 29),
mark the locations for the 3/16" holes and
the 1" center hole.
• Check carefully to ensure there are no obstructions behind the console before
drilling any holes.
• Using a 1" diameter hole-saw, drill the center hole. Use a 3/16" drill for the four
mounting stud holes.
• Place the helm display keypad onto the console, feeding the pre-connected wires
through the 1" center hole while inserting the screws into each of the four holes.
• Once the control plate is properly seated, use the 4 white nylon thumb nuts
provided to secure the display.
• Connect the orange wire to the power source for the gauges at the helm. This
will power the control with all other dash devices.
• Connect the purple wire to the ignition switch (or any 12V circuit that turns
ON and OFF with ignition) for auto tab retraction. This wire is used to initiate
Auto Tab Retraction (ATR) when the ignition is switched to the OFF position.
If ATR is not desired, this connection may be omitted.
• Relay Module is required (see page 21).
• Turn the battery on.
• For troubleshooting, see page 34
Bennett Marine | Bolt Electric Trim Tab System
continued
19
Advertisement
Table of Contents
