Bennett Marine BOLT Installation & User Manual page 14

Actuator & Tab Installation
Mounting Adjustable Upper
Hinge Actuators (BEA3000)
to the Transom
• Temporarily detach the actuator
from the lower hinge by
unscrewing the 1/4-20 x 3/4 screws.
• Carefully insert end of the electrical
cable through the adjustable upper
hinge mount and install the sealing
grommet onto the cable.
• Pull the cable through the upper
hinge mount until the mount is
about 8" from the actuator.
• Insert the end of the cable through
the transom hole.
• Temporarily mount the actuator to
the adjustable upper hinge using
the supplied 5/16-18 bolt and lock
nut to set the cable length.
14
grommet with
small end toward
the upper hinge
mount
Bennett Marine | Bolt Electric Trim Tab System
continued
• Temporarily mount the upper
hinge of the new actuator to the
transom using (2) of the supplied
#14 x 1-1/2" screws in the lower
Lower Mounting Positions
mounting positions, leaving a gap
of 1/4" between the upper hinge
and the transom. Pull the excess
cable though the transom leaving
enough cable to prevent the
actuator from binding during its
normal movement.
No screw for top hole
Slack
• Ensure that the cable sealing
grommet is moved down the cable
to its seat on the upper hinge.
1/4" gap
#14 x
1-1/2"
screws