Bennett Marine BOLT Installation & User Manual page 35

» If the red power LED is
illuminated and the green
power LED is flashing and
the system is still not working,
please contact Bennett Marine
Client Services.
• Problem: One tab moves and one
does not.
» On the actuator that is not
moving, disconnect the
actuator from the harness.
Remove the orange wedge-
lock from the connector
and inspect the connector
contacts. The contact must
be seated evenly and all the
way up to the end of the
connector for the mating pins
to make contact. Push the
wires up into the connector
until the contacts snap in
place. Replace the orange
wedge-lock, reconnect the
actuator to the extension cable
and retest.
• Problem: Actuator extends when
BOW UP Button is pressed and
actuator retracts when BOW
DOWN is pressed.
» The actuator wires are reversed
in the connector. Disconnect
the actuator that is not
moving properly. Remove
the orange wedge-lock from
the connector. Remove the
contacts from the connector
Bennett Marine | Bolt Electric Trim Tab System
Troubleshooting
continued
using a small straight blade
screw driver to release the
internal snaps. Re-insert
the actuator wires into the
connector in the reverse order.
Re-insert the orange wedge-
lock into the connector.
Reconnect the actuator to the
extension cable and re-test.
• Problem: The port (left) Actuator
extends when the port (left) BOW
DOWN button is pressed and stbd.
(right) actuator extends when stbd.
(right) BOW DOWN button is
pressed.
» The actuators are reversed.
Unplug the actuators at the
extension cable and switch
the connections between the
extension cablees and the
actuators.
Troubleshooting Systems
with Indicator
Controls (BCI8000)
• Problem: Both tabs not moving.
» Check that batteries are
turned on and charged.
» Check that the red LED on
the top center of the BCI
relay module is on and bright.
» Verify that the green
communications LED is
flashing. If the green LED is
35