Qlima S-54 Series Operating Manual page 47

FP function
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8°C/46°F.
NOTE: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F to activate FP function. Press On/Off, Sleep, Mode, Fan and Temp. button while
operating will cancel this function.
LOCK function
Press together Clean button and Turbo button at the same time more
than 5 seconds to activate Lock function. All buttons will not response
except pressing these two buttons for two seconds again to disable locking.
SHORTCUT function
Press SHORTCUT button (some units). Push this button when remote controller is on,
the system will automatically revert back to the previous settings including operating
mode, setting temperature, fan speed level and sleep feature (if activated).
If pushing more than 2 seconds, the system will automatically restore the
current operation settings including operating mode, setting temperature,
fan speed level and sleep feature (if activated ).
Clean Function
Press CLEAN button. Airborne bacteria can grow in the moisture that condenses around
heat exchanger in the unit. With regular use, most of this moisture is evaporated from
the unit. By pressing the CLEAN button, your unit will clean itself automatically. After
cleaning, the unit will turn off automatically. Pressing the CLEAN button mid-cycle will
cancel the operation and turn off the unit. You can use CLEAN as often as you like.
Note: You can only activate this function in COOL or DRY mode.
TURBO function
Press turbo button. When you select turbo feature in COOL mode,
the unit will blow cool air with strongest wind setting to jump-start the cooling process.
When you select turbo feature in HEAT mode, for units with Electric heat elements,
the Electric HEATER will activate and jump-start the heating process.
SET function
Press the SET button to enter the function setting, then press SET button or TEMP ▲ or ▼ button to
•
select the desired function. The selected symbol will flash on the display area, press the OK button to
confirm.
Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 47 Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 47
GB
47
02-11-2021 11:32 02-11-2021 11:32