Ehow To Use Basic Functions - Qlima S-54 Series Operating Manual

Hide thumbs Also See for S-54 Series:
Table of Contents

Advertisement

G
NOTE!
All items are shown in the Fig. 2 for the purpose of clear presentation. But during the actual
operation only the relative functional items are shown on the display panel.
Operating the Remote Controller
Install / Replace Batteries
Use two dry alkaline batteries (AAA/LR03).
Do not use rechargeable batteries.
1.
Remove the battery cover on the back of the Remote Control by pulling it according to the arrow
direction shown on the cover.
2.
Insert new batteries making sure that the (+) and (-) of battery are installed correctly.
3.
Reattach the cover by sliding it back into position.
G
NOTE!
• When the batteries are removed, the remote controller erases all programming. After inserting
new batteries, the remote controller must be reprogrammed.
• When replacing batteries, do not use old batteries or a different type battery. This may cause
the remote controller to malfunction.
• If you do not use the remote controller for several weeks remove the batteries. Otherwise
battery leakage may damage the remote controller.
• The average battery life under normal use is about 6 months.
• Replace the batteries when there is no answering beep from the indoor unit or if the
Transmission Indicator light fails to appear.
• Never mix new and old batteries. Never use different battery types (e.g. alkaline and
manganese dioxide) simultaneously.
E
HOW TO USE BASIC FUNCTIONS
BASIC OPERATION
ATTENTION! Before operation, please ensure the unit is plugged in and power is available.
SETTING TEMPERATURE
The operating temperature range for units is 17-30°C (62-86°F)/ 20-28°C. You can increase or decrease
the set temperature in 1°C (1°F) increments.
AUTO mode
In AUTO mode, the unit will automatically select
the COOL, FAN, or HEAT operation based on
the set temperature.
1.
Press the MODE button to select AUTO.
Set your desired temperature using the TEMP ▲ or ▼ TEMP button.
2.
3.
Press the ON/OFF button to start the unit.
NOTE: FAN SPEED can't be set in AUTO mode.
Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 43
Q_man_S(C)46xx-S(C)54xx–S(C)JAxx22 SCAN ('21) V1.indd 43
GB
43
02-11-2021 11:32
02-11-2021 11:32

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents