Setting The Network Id In Extended Addressing Mode; Manually Assign A Binding Code To A Gateway - Banner Sure Cross DX80 Instruction Manual

®
Sure Cross DX80 Performance Wireless I/O Networks
3. Repeat steps 1 and 2 for all Nodes that will communicate to this Gateway.
4. Write 0x0000 (hex) to the Gateway's register 6371 to stop the binding procedure.
For more information about using Modbus commands, refer to Host Controller Systems instruction manual (p/n 132114).

5.3 Setting the Network ID in Extended Addressing Mode

Use the menu system to set the Network ID when using extended address mode.
1. From the top level menus, single-click button 1 to advance through the menus, stopping at DVCFG (Device
Configuration).
The Gateway's LCD displays DVCFG.
2. Single-click button 2 to enter the DVCFG menu options and stop at (NID).
The Gateway's LCD displays (NID).
3. Single-click button 2.
Enters the (NID) menu option.
4. Using both rotary dials on the Gateway, select a Network ID. The left rotary dial acts as the left digit and the right
rotary dial acts as the right digit of the Network ID. In extended addressing mode, the Network ID can only be set
from the rotary dials while in the (NID) menu.
Any Nodes bound to this Gateway 'follow' the Gateway to the new Network ID automatically. The current Network ID
and the new Network ID display on the LCD panel.
5. Single-click button 2.
Saves the new values.
6. Double-click button 2.
Exits this submenu and the LCD displays (NID).
7. Double-click button 2.
Exits to the main menu system and returns to RUN mode. The LCD displays DVCFG.

5.4 Manually Assign a Binding Code to a Gateway

Manually assign the binding code (XADR) when replacing components of an existing wireless network.
To determine the existing binding code, access the DINFO (Device Information) menu of either the existing Gateway or
another Node in the network. Follow the submenu structure to the XADR display for that device.
1. Apply power to the Gateway.
The Gateway's LCD shows POWER, then RUN.
2. On the Gateway, single click button 1 to advance across the menus, stopping at the DVCFG menu.
The Gateway's LCD shows (DVCFG).
3. Single click button 2 to select DVCFG. Single click button 1 to select from the available menu options, stopping at
XADR.
4. Single click button 2 to enter the XADR menu.
AUTO is automatic binding mode and uses the Gateway's serial number as the binding code.
5. Single click button 1 to select manual mode.
6. Single click button 2 to enter manual mode.
MANUAL allows the user to manually enter an binding code.
7. Single click button 2 to advance to the binding code entry step.
After entering manual mode, use the right rotary dial to select the digits of the binding code. The LCD shows SET
XADR 000000.
8. Use the right rotary switch to begin setting the binding code. Digit selection begins with the left most digit. After
selecting the first digit, single click button 1 to advance right to the next digit. All six digits must be filled, even if it is
with leading zeros. For example, to use 2245 as the code, enter 002245 into the device.
To use the Gateway's serial number, enter 000000 as the binding code.
9. Continue entering the code using a single click of button 1 to advance from left to right.
After reaching the sixth digit, the curser returns to the first digit.
34 www.bannerengineering.com - Tel: + 1 888 373 6767