Epson STYLUS PHOTO 2000P Instruction Manual page 36

One of the first things you should decide is what width of roll
paper you will be using. This will determine what Paper Source
setting you will need to make. Select Roll Paper as the Paper
Source in the printer driver if you are printing on A4 or 329-mm
width roll paper. If you are using 89- or 100-mm width roll paper,
select Roll Paper or Roll Paper - No Margins
below for details.
With Roll Paper selected as the Paper Source, a
3-mm margin will be left along both sides of the
paper. The top margin above the print data will
be set to 20 mm.
When printing is finished, press the
button once to print a cutting guideline about 12
mm from the bottom of the print data.
To print the next print job, press the
button again. The space between the two
blocks of print data will be 36 mm.
With Roll Paper selected as the Paper Source, a
3-mm margin will be left along both sides of the
paper when printing data which spans multiple
pages in your application. The margin between
pages will be set to 0, but the margin between
print jobs will remain 36 mm.
With Roll Paper - No Margins selected as the
Paper Source, no margin will be left along either
side of the paper. The top margin above the print
data will be set to 20 mm.
When printing is finished, press the
button once to print a cutting guideline about 12
mm from the bottom of the print data.
To print the next print job, press the
button again. The space between the two
blocks of print data will be 36 mm.
1-18
Paper Handling
E
load/eject
E
load/eject
E
load/eject
E
load/eject
.
Refer to the table