Connecting The Tp-43 Component - S/Pdif Transceiver; Connecting A Tp-43 Component - S/Pdif Transceiver - Kramer TP-43 User Manual

Connecting the TP-43 Component – S/PDIF Transceiver
5 Connecting the TP-43 Component – S/PDIF Transceiver
This section describes how to connect:
The TP-43, see section 4.1
An extended Component – S/PDIF distribution system by connecting three
TP-43 units between the TP-41 and the TP-42, see section 4.2
5.1 Connecting a TP-43 Component – S/PDIF Transceiver
To configure a TP-43 Component – S/PDIF Transceiver, as the example in
Figure 5 illustrates, do the following:
1. Connect the:
Y, U, and V RCA (component video) OUTPUT connectors to a
component acceptor (for example, a plasma display)
S/PDIF (digital audio) RCA OUTPUT connector to an AV Receiver
2. Connect the LINE IN connector of the TP-43 to the LINE OUT connector
of the TP-41, via UTP cabling (maximum range of 300ft (100m)).
3. Connect the LINE OUT connector of the TP-43 to the LINE IN connector
of the TP-42, via UTP cabling (maximum range of 300ft (100m)).
4. Connect a 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 5).
5. If necessary, adjust
Local output: Y, U and V signal levels, Y, U and V compensation
equalization levels, and the digital audio S/PDIF level and compensation
equalization level
Line output: Y, U and V signal levels, and the digital audio S/PDIF level
1 Insert a screwdriver into the small hole and carefully rotate it, trimming the level
6
1
the appropriate level(s) of the TP-43, the:
KRAMER: SIMPLE CREATIVE TECHNOLOGY