5
Using the TP-576 HDMI / CAT 5 Line Driver
This section describes how to:
•
Connect the TP-576 (see section 5.1)
•
Connect RS-232 ports (see section 5.2)
•
Connect the IR emitters and sensors (see section 5.3)
•
Wire the CAT 5 RJ-45 connectors (see section 5.4)
•
Use the EDID SETUP button (see section 5.5).
5.1
Connecting the TP-576 HDMI /CAT 5 Line Driver
To connect the TP-576 together with the TP-573 HDMI/RS-232/IR Line
Transmitter and the TP-574 HDMI/RS-232/IR Line Receiver, as illustrated
in the example in
On the TP-573 connect:
1. An HDMI source (for example, a DVD player) to the HDMI IN connector.
2. An IR sensor or emitter to the IR 3.5mm mini jack connector (see
section 5.3).
3. A PC to the RS-232 9-pin D-sub connector.
Alternatively, you can connect an RS-232 controllable device to the
RS-232 port of the TP-573 and a PC to the RS-232 port of the TP-574
4. A CAT 5
On the TP-576 connect:
1. An HDMI source (for example, a DVD player) to the HDMI INPUT 1
connector.
2. The CAT 5 or CAT 6 cable
twisted pair connector.
3. An IR sensor or emitter to the REMOTE IR 3.5mm mini jack connector
(see section 5.3).
4. The 12V DC power supply
On the TP-574 connect:
5. The HDMI OUT connector to an HDMI acceptor (for example, an LCD
display with speakers).
6. An IR emitter or sensor to the IR 3.5mm mini jack connector (see
section 5.3).
1 See section
5 2
2 Using the Kramer BC-DGKat524 or BC-DGKat623 cable, respectively
3 To power the TP-576 as well as the TP-573 and TP-574
8
Using the TP-576 HDMI / CAT 5 Line Driver
Figure
2, do the following:
2
2
or CAT 6 cable to the LINE OUT RJ-45 twisted pair connector.
2
from the TP-573 to the INPUT 2 RJ-45
3
to the TP-576 (not shown in
KRAMER: SIMPLE CREATIVE TECHNOLOGY
1
.
Figure 2
).