Connecting the TP-202 Wiring the TP LINE IN / LINE OUT RJ-45 Connectors Technical Specifications Figures Figure 1: TP-202 UXGA Line Transceiver/DA Figure 2: TP-202 (Underside Panel) Figure 3: Connecting the TP-202 UXGA Line Transceiver/DA Figure 4: TP PINOUT TP-202 – Contents...
Introduction Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been providing a world of unique, creative, and affordable solutions to the vast range of problems that confront video, audio, presentation, and broadcasting professionals on a daily basis. In recent years, we have redesigned and upgraded most of our...
Avoid interference from neighboring electrical appliances that may adversely influence signal quality Position your Kramer TP-202 away from moisture, excessive sunlight and dust This equipment is to be used only inside a building. It may only be connected to other equipment that is installed inside a building.
Kramer Electronics has made arrangements with the European Advanced Recycling Network (EARN) and will cover any costs of treatment, recycling and recovery of waste Kramer Electronics branded equipment on arrival at the EARN facility. For details of Kramer’s recycling arrangements in your particular country go to our recycling pages at http://www.kramerelectronics.com/support/recycling/.
Overview The TP-202 is a twisted pair branching receiver for computer graphics video signals with resolutions from VGA up to UXGA and higher or HDTV signals. It takes a twisted pair signal and converts it into a computer graphics video signal or HDTV signal available on two 15-pin HD outputs, and simultaneously re-transmits the original twisted pair signal to another compatible receiver.
STP cable. There are different levels of STP cable available, and we advise you to use the best quality STP cable that you can afford. Our non-skew-free cable, Kramer BC-STP is intended for analog signals where skewing is not an issue.
For example, the PT-110, as Figure 3 illustrates 12V DC +12V DC connector for powering the unit Figure 2 defines the TP-202 underside panel: Figure 2: TP-202 (Underside Panel) Feature Function VS Switch Slide the switch to NORMAL to retain the polarity...
This lets you transmit a computer graphics signal to two displays via long line CAT 5 UTP cabling. By using two TP-202 units, you can transmit the signal to an additional TP-202. To connect the TP-202, as the example in...
TP-202, decoded and converted at the UXGA OUT 1 and UXGA OUT 2 15-pin HD connectors to the UXGA acceptors simultaneously. When chaining several units, we recommend using an STP cable between the transmitter and the receiver and a skew-free cable for connecting the TP-202 units.
Note, that the cable Ground shielding must be connected / soldered to the connector shield. Figure 4: TP PINOUT EIA /TIA 568B Wire Color Orange / White Orange Green / White Blue Blue / White Green Brown / White Brown TP-202 - Connecting the TP-202...
@50MHz COUPLING: Receiver section: DC, looping section: AC 12V, 525mA maximum current (when feeding TP-219HD POWER CONSUMPTION: (as the transmitter) and a looped TP-202) OPERATING 0° to +40°C (32° to 104°F) TEMPERATURE: STORAGE TEMPERATURE: -40° to +70°C (-40° to 158°F)
Page 15
For the latest information on our products and a list of Kramer distributors, visit our Web site where updates to this user manual may be found. We welcome your questions, comments, and feedback. Web site: www.kramerelectronics.com E-mail: info@kramerel.com SAFETY WARNING...
Need help?
Do you have a question about the TP-202 and is the answer not in the manual?
Questions and answers