Modify the terminator to be the letter 0x0D Example:
1. Read the "Enable Setting Code" (if it is already turned on, you can ignore it);
2. Read the "modify end character" setting code;
3. Read the data code "0", "D";
4. Read "Save";
5.8.3 Quick configuration terminator
Closing terminator
Add carriage return and line feed CRLF
Add tab stops TAB
5.9 Data segment editing
5.9.1 Data segment interception
The decoding information Data consists of 3 parts: [Start] [Center] [End].
The user can select part of the information to be output by reading the following setting
codes.
*Transfer the entire Data
Only the End segment is transmitted
*to add the carriage return CR
Add LF
Add terminator
Only transfer the Start segment
Only transfer Center segment
20
ETX