Maintenance; Install Upgrade And Key Tokens - Graco 26A010 Instructions Manual

Maintenance

Maintenance Maintenance
Install Upgrade Upgrade and and Key
Install Install Upgrade and
NOTE: Fluid Control Module (FCM) connection to the NOTE: NOTE:
system is temporarily disabled during the installation
of upgrade or key tokens.
1. Ensure the system is inactive.
2. Remove access cover (AJ).
3A3465A
Key Tokens Tokens
Key Tokens
3. Insert and press token (T) firmly into slot.
NOTE: NOTE: There is no preferred orientation of token. NOTE:
4. Press and hold button the push button (AK) for
three seconds and then release. The red LED
(AL) will flash until the software is uploaded.
5. Remove token (T) when software has
successfully uploaded or key token is no longer
required.
NOTE: NOTE: Upgrade tokens can be removed once NOTE:
the software has been successfully uploaded.
If key tokens are used by your Graco Control
Architecture based system, they must remain in
the FCM for features or settings to be enabled.
Key tokens are not present on all Graco Control
Architecture based settings.
6. Replace the access cover (AJ).
Maintenance
15