Fan Air Solenoid Repair; Atomizing Air Solenoid Repair; Repair - Graco 26A010 Instructions Manual

Fan Air Air Solenoid Solenoid Repair
Fan Fan Air Solenoid
1. Remove the cover
(see Cover Removal, page 18
2. Remove the inlet hose at the fan air inlet (MB).
3. Remove the outlet hose at the fan air outlet (MC).
4. Remove the control cable from the Fluid Control
Module (A) at MA.
5. Loosen the two screws (37) securing the solenoid
assembly (M) to the enclosure panel (15), and
remove the solenoid assembly.
6. If you are removing the
atomizing air solenoid (N), see
Atomizing Air Solenoid Repair, page 19
continuing to the next step.
7. Orient the new fan air solenoid (M) with the
control port (MA) pointing to the left, and secure
the solenoid to the enclosure panel (15) with the
two screws (37) at diagonal holes.
8. Attach the control cable from the Fluid Control
Module (A) at MA.
9. Attach the outlet hose to the shaping air outlet
(MC).
10. Attach the inlet hose to the shaping air inlet (MB).
Atomizing Atomizing Atomizing Air Air Solenoid Air Solenoid Repair Solenoid
1. Remove the cover
(see Cover Removal, page 18
2. Before removing the atomizing air solenoid
(N), remove the fan air solenoid (M), see
Fan Air Solenoid Repair, page
3. Remove the inlet hose at the shaping air inlet
(NB).
4. Remove the outlet hose at the shaping air outlet
(NC).
3A3465A

Repair

Repair
).
before
Repair Repair
).
19.
5. Remove the control cable from the Fluid Control
Module (A) at NA.
6. Loosen the two screws (37) securing the solenoid
assembly (N) to the enclosure panel (15), and
remove the solenoid assembly.
7. Orient the new atomizing air solenoid (N) with the
control port (NA) pointing to the left, and secure
the solenoid to the enclosure panel (15) with the
two screws (37) at diagonal holes.
8. Attach the control cable from the Fluid Control
Module (A) at NA.
9. Attach the outlet hose to the shaping air outlet
(NC).
10. Attach the inlet hose to the shaping air inlet (NB).
11. Reinstall the fan air solenoid (M), see
Fan Air Solenoid Repair, page
Paint Trigger/Auxiliary Paint Paint Trigger/Auxiliary Air Trigger/Auxiliary
Repair Repair Repair
The following procedure applies to any of the paint
trigger (D) or auxiliary air solenoids (E, F, and G).
1. Disconnect the air hose from the solenoid outlet
(24).
2. Disconnect the splitter cable (13).
3. Remove the solenoid (12) by loosening the two
screws on the solenoid.
4. Orient the new solenoid (12) with the cable
connection facing inwards and the solenoid outlet
facing outwards, and secure the solenoid to the
enclosure panel with the two screws.
5. Attach the splitter cable (13).
6. Attach the air hose to the solenoid outlet (24).
Repair
19.
Air Solenoid Air Solenoid Solenoid
19