Table of Contents
Advertisement
6. Network control
❶ Network control operation
Function: This function is designed to remote control the projector from your computer in the same LAN.
Preparation
1. Required equipment: Projector, Computer, Network cable
2. Connection:
Connect the projector to the router or switch in the LAN with a straight or crossover network cable. If you connect
the projector and the computer directly, you cannot connect with a straight-through network cable.
It is recommended to use a crossover network cable.
3. Turn on the computer. The LAN port on computer and projector are flashing after turn on the projector.
NOTE:
• It is recommended that users use a Category 5 or higher LAN cable.
Operation steps
1. Turn on your projector.
2. Acquire the IP address, with DHCP set to "On" and auto IP allocation set to on. (You may set DHCP to "Off" and
set up IP address manually if you are somehow familiar with networking.)
3. Enter the network setup menu.
(1) Press the MENU button on remote control or the top control panel, press
Press the ENTER or
(2) Press
button select [Network setup] and press the ENTER button to enter.
MAC address......Display the MAC address of wired LAN.
IP address...........Display the IP address of wired LAN.
(3) Press
button select [Network setting] and press the ENTER button to enter.
(4) Press
button to set DHCP "On" to obtain an IP address, Subnet , Gateway and DNS automatically, and
press the ENTER button to confirm.
Expand
Network Setup
Network setting
Network information
MAC address:
IP address
button to set DHCP "Off", then press the ENTER button to enter an IP address, then press ▼ button
Press the
to enter Subnet , Gateway and DNS manually. And press the ENTER button to confirm.
Expand
Network Setup
Network setting
Network information
MAC address:
IP address
(5) Press
button to select [Set], press the ENTER button to wait until the "Please wait." message disappears.
NOTE:
• If you are using the wireless LAN connection, please check the SSID / ESSID and wireless IP address in the network setting status, and
write down the information.
button.
Wired LAN
7C:6F:F8:4E:B9:2F
IP address
192.168.1.100
Subnet
Gateway
Wireless LAN
： Move
Wired LAN
7C:6F:F8:4E:B9:2F
192.168.1.100
Wireless LAN
： Move
DHCP
off
192 . 168 .
1 . 1
255 . 255 . 255 . 0
192 . 168 .
1 . 1
DNS
0
. 0
.
0 . 0
Setting
On
Set
Cancel
： Next
： Back
ENTER
EXIT
DHCP
On
IP address
.
.
.
Subnet
.
.
.
Gateway
.
.
.
DNS
.
.
.
Setting
On
Set
Cancel
： Next
： Back
ENTER
EXIT
61
button to select [Expand] icon.
Advertisement
Table of Contents
