[Cooling Fast] - NEC PE506WL User Manual

2) Press the ENTER button.
3) Press ▲ ▼ button to select required menu.
Off: Normal speed. set the option off when operating the operator, if the altitude is not too high.
On: Faster than when in off mode .set the option on when operating the operator in high land.
Setting
On start
Standby mode
High altitude
Cooling fast
Key lock
Contrast optimization
Baud rate
Laser control
Sound
HDMI setup
Note:
• The air pressure sensor will sense the altitude automatically. When the altitude is at an altitude of approximately 1700 meters/ 5577 feet
or higher, projector will turn on the High altitude function automatically, thus the On-screen menu of High altitude will change to "On".
• If the air pressure sensor is damaged, the projector OSD menu will turn red for reminding that the automatic transfer to high altitude
function is invalid. User could set High altitude to "On" manually .
• When setting condition is over approximately 2600 meters / 8530 feet , automatically brightness is reduced to protect unit.
• This unit can be used at approximately 3000 meters / 9843 feet , once over that altitude units automatically turn down to protect unit.

[Cooling fast]

Select the cooling time after projector is turned off.
1) Press ▲ ▼ button to select [Cooling fast] menu.
2) Press the ENTER button.
3) Press ▲ ▼ button to switch required menu.
60 Sec.....Cooling down in 60 seconds after the projector is turned off.
30 Sec...... Cooling down in 30 seconds after the projector is turned off. And the cooling fan will runs faster then in
the normal cooling way with shorter time but it will sounds louder.
0 Sec.......Cooling down instantly after the projector is turned off.
Setting
On start
Standby mode
High altitude
Cooling fast
Key lock
Contrast optimization
Baud rate
Laser control
Sound
HDMI setup
Note:
• Cooling fast function depends on whether user needs to move the projector immediately. If the user needs to unplug the power to
move the projector immediately, you can choose "0 Sec", or we can select the "60 Sec" option.
Off
Normal
Off
60 Sec
Off
Off
9600
Off
Normal
Off
60 Sec
Off
Off
9600
43
5. Using On-Screen Menu