❿ Turning Off The Projector - NEC PE506WL User Manual

❿ Turning off the Projector
To turn off the projector:
1. First, press the
cabinet or the STANDBY button on the remote control.
The confirmation message will be displayed.
Carbon savings-session
66.5200
2. Secondly, press the ENTER button or press the
(POWER) or the STANDBY button again.
The light source will turn off and the projector will go into
standby mode. When in standby mode, the POWER indica-
tor will blinking orange and the STATUS and LIGHT indica-
tor will turn off when [Normal] is selected for [STANDBY
MODE].
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if
the AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
NOTE:
• While the power indicator is blinking blue in short cycles, the power cannot be turned off.
• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.
• Do not disconnect the AC power supply to the projector within 10 seconds after making adjustment or setting changes and closing the
menu. Doing so can cause loss of adjustments and settings.
(POWER) button on the projector
Power off?
Yes No
[g-CO2]
2. Projecting an Image (Basic Operation)
Power On
Steady blue light
Steady blue light
Standby
Blanking orange light
24
Steady green light
or
Blanking green light