Table of Contents
Advertisement
7. NETWORK SETTINGS
Configuration for connecting this device to a wired LAN or wireless LAN.
7-1. PROJECTOR NAME
Set the projector name and host name. The default factory setting is the manufacturing number of this device.
Item
Projector name
Host name
7-2. NETWORK INFORMATION
Display the information when this device is connected to a network (wired LAN / wireless LAN).
7-3. WIRED LAN
Configure the settings for connecting this device to a wired LAN.
Item
Profile
DHCP/IP ADDRESS/
S U B N E T M A S K /
GATEWAY/AUTO-
MATIC DNS
Reconnection
NOTE:
• If you cannot obtain IP address by disconnecting/connecting the LAN cable under the state the DHCP has been set, power off this
device once and then power it on again.
7-4. Wireless LAN
Configure the settings for connecting this device to a wireless LAN.
Item
Profile
DHCP/IP address/
Subnet mask/Gate-
way/DNS
Advanced settings
Reconnection
Description
Set up the projector name
Set the host name of this device.
Description
The settings when connecting this device to a wired LAN can
be registered in 2 ways (Profile 1 and Profile 2).
Perform required settings
Try connecting to the network again. Reconnect after chang-
ing the settings.
Description
Select the configuration name when connecting this device
to a wireless LAN.
• Disable: No radio waves will be transmitted from the wire-
less LAN unit connected to this device.
• INTELLIGENT CONNECTION
This function enables connection to the projector using the
MultiPresenter application by inputting a PIN code (4-digit
number).
• Simple access point: Connect to a computer or smartphone
by setting this device as a simple access point.
• Wi-Fi Direct: Connect to a device compatible with Wi-Fi
Direct.
• Miracast: Connect to a device compatible with Miracast
• Profile 1 / Profile 2: The wireless LAN settings can be reg-
istered in 2 ways.
These can be set when Profile 1 or Profile 2 is selected.
The configuration items differ for each profile option. Refer
to the following table.
Try connecting to the network again. Reconnect after chang-
ing the settings.
22
Remarks
A maximum of 16 alphanumeric
characters
A maximum of 16 alphanumeric
characters
Remarks
Remarks
• The default factory setting
when shipped is "Disable".
• If a simple access point
has been set up, the IP
address of this device
will be "192.168.120.1" or
"192.168.130.1".
NOTE: When a simple access
point is set up. Up to 20 units can
be connected simultaneously.
Recommend to connect approx.
10 units for normal operation.
Advertisement
Table of Contents
