Monitoring Parameters - Savch S3100E Series User Manual

22-06 Undervoltage level
Setting range
It is used to set the voltage value of the undervoltage fault UV of the inverter. 100.0% of the inverters with different
voltage levels correspond to different voltage points, respectively:
Single-phase 220V or three-phase 220V: DC200V
Three-phase 380V: DC350V
22-07 Reserved

99 Monitoring Parameters

The 99 parameter group is used to monitor the running status information of the inverter. The user can view it
through the operation panel, or read the value of the parameter group through communication in order to view the
data on the spot or monitor the data of the host computer. Among them, 99-00 to 99-31 are the same as the
monitoring parameters defined in 08-03/08-04.
See the table below for details.
Parameter Name
99-00 Running frequency(Hz)
99-01 Setting frequency(Hz)
99-02
Bus voltage(V)
99-03
Output voltage(V)
99-04
Output current(A)
99-05
Output power(kW)
99-06 Output torque(%)
99-07 MI Input status
99-08 MO Output status
99-09 AVI1 Voltage(V)
99-10 AVI2/ACI Voltage(V)
99-11 Reserved
99-12 Calculation value
99-13 Length
99-14 Load speed
99-15
PID setting
99-16
PID feedback
99-17 PLC stage
99-18 PULSE Input pulse frequency(Hz)
99-19 Feedback speed(Unit 0.1Hz)
99-20 Remaining running time
99-21
AVI1 voltage before calibration
DC200V-DC420V

132
220V:200V
Factory setting
380V:350V
Factory setting
Unit
0.01Hz
0.01Hz
0.1V
1V
0.01A
0.1kW
0.1%
1
1
0.01V
0.01V
1
1
1
1
1
1
0.01kHz
0.1Hz
0.1Min
0.001V