Multi-Format Set Hs-P1 (Sold Separately) - Minolta Dimage Scan Multi Pro Hardware Manual

With the emulsion down, place the film on the
attachment. Align the frame with the attachment
aperture.
Carefully close the cover until the latch clicks. See
page 15 for instructions on how to load the holder
into the scanner.

Multi-format Set HS-P1 (sold separately)

The multi-format attachment allows non-standard
film sizes to be scanned. The set includes the
multi-format attachment cover (1), the multi-format
attachment base (2), and a set of three masks
(FM-P2)(3).
The Multi-format attachment is designed for non-standard film sizes, special technical films, and
non-photographic transparent media. The maximum area that can be scanned at one time is
56.58 mm X 83.82 mm. This attachment can be used for 16 mm film, microfilm, or 24 X 65 mm
panoramic images. TEM (transmission electron microscopy) film can also be scanned. However,
since the image area of some TEM films is larger than the holder aperture, several scans need to
be made and then the image must be reconstructed digitally.
Slide the left side of the attachment base into
the Universal Holder so the two protrusions on
the attachment are aligned to the two slots in
the holder.
Carefully press the right side of the base down
until the latch in the Universal Holder clicks.
1
2
Insert the two pin on the attachment cover into
the two corresponding holes in the Universal
Holder. Both pins should click into place.
3
13