Table of Contents
Advertisement
9.3
Minimum Chimney Height
The top of the chimney should be tall enough to be above the air turbulence caused when wind blows
against the house and its roof. The chimney must extend at least 3' (1 m) above the highest point of
contact with the roof, and at least 2' (60 cm) higher than any roof line or obstacle within a horizontal
distance of 10' (3 m).
Figure 26: Flat roof
9.4
Chimney Location
Because the venting system is the engine that drives the wood heating system, it must have the
right characteristics. The signs of bad system design are cold back drafting when there is no fire
in the stove, slow kindling of new fires, and smoke roll-out when the door is opened for loading.
There are two guidelines to follow. First, the chimney should be installed up through the heated
space of the house, not outside up on the wall. Second, the chimney should ideally go through
the highest heated space of the building or near the highest heated space.
Venting systems that rise straight up from the stove flue collar provide the best performance.
Chimneys that rise inside the warm space of the house tend to provide a small amount of draft
even when there is no fire burning. This means that when a fire is lit, the smoke goes up the
chimney and strong draft build quickly as the chimney flue warms up. Although they are common
in North America, chimneys that exit a house wall and run up outside can cause problems.
Page 56
Figure 27: Sloping roof
Installation and operation manual – Chic-Choc woodburning cookstove
Advertisement
Table of Contents
