Advertisement
IV
Installation Suggestions
If you plan to install this camera enclosure into a tropical, sea coastal, or an environment
where salt water or corrosive industrial waste water/moist are present, please seal each
stainless steel screws and fittings with a silicon grease compounds. This will help prevent
electrolysis to occur and extend the life span of the camera and housing.
IMPORTANT:
1. Disconnect devices: A readily accessible disconnect device in the building installation wiring
should be incorporated.
2. Electrical Connection: Only a qualified electrician is allowed to make electrical connections.
V
Installation
1.
Prepare the AC24V power wires and a CAT5e Ethernet cable. Pass them through the
waterproof connectors.
4
Advertisement
