Status Display - Siemens SINUMERIK 840D sl Universal Operating Manual

⑥
⑦
⑧
⑨
⑩
⑪
⑫
3.4.2

Status display

The status display includes the most important information about the current machine status
and the status of the NCK. It also shows alarms as well as NC and PLC messages.
Depending on your operating area, the status display is made up of several lines:
• Large status display
The status display is made up of three lines in the "Machine" operating area.
• Small status display
In the "Parameter", "Program", "Program Manager", "Diagnosis" and "Start-up" operating
areas, the status display consists of the first line from the large display.
Status display of "Machine" operating area
First line
Ctrl-Energy - power display
Display
The power display must be switched on in the status line.
Additional information on configuring is provided in the
Ctrl‑Energy System Manual.
Active operating area
Display
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Display of active G functions, all G functions, auxiliary functions and input window for different
functions (for example, skip blocks, program control).
Horizontal softkey bar
Dialog line to provide additional user notes.
Operating window with program block display
Position display of the axes in the actual values window
Channel state and program control
Program name
Meaning
The machine is not productive.
The machine is productive and energy is being consumed.
The machine is feeding energy back into the supply system.
Meaning
"Machine" operating area
In touch mode you can switch over the operating area here.
"Parameter" operating area
"Program" operating area
Fundamentals
3.4 Operator interface
43