Display G And Auxiliary Functions; Selected G Functions - Siemens SINUMERIK 840D sl Universal Operating Manual

7.12

Display G and auxiliary functions

7.12.1

Selected G functions

16 selected G groups are displayed in the "G Function" window.
Within a G group, the G function currently active in the controller is displayed.
Some G codes (e.g. G17, G18, G19) are immediately active after switching the machine control
on.
Which G codes are always active depends on the settings.
G groups displayed by default
Group
G group 1
G group 2
G group 3
G group 6
G group 7
G group 8
G group 9
G group 10
G group 13
G group 14
G group 15
G group 16
G group 21
G group 22
G group 29
G group 30
G groups displayed by default (ISO code)
Group
G group 1
G group 2
G group 3
G group 6
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Meaning
Modally active motion commands (e.g. G0, G1, G2, G3)
Non-modally active motion commands, dwell time (e.g. G4, G74, G75)
Programmable offsets, working area limitations and pole programming (e.g.
TRANS, ROT, G25, G110)
Plane selection (e.g. G17, G18)
Tool radius compensation (e.g. G40, G42)
Settable work offset (e.g. G54, G57, G500)
Offset suppression (e.g. SUPA, G53)
Exact stop - continuous-path mode (e.g. G60, G641)
Workpiece dimensions, inch/metric (e.g. G70, G700)
Workpiece dimensioning absolute/incremental (G90)
Feed type (e.g. G93, G961, G972)
Feedrate override at inside and outside curvature (e.g. CFC)
Acceleration profile (e.g. SOFT, DRIVE)
Tool offset types (e.g. CUT2D, CUT2DF)
Radius/diameter programming (e.g. DIAMOF, DIAMCYCOF)
Compressor on/off (e.g. COMPOF)
Meaning
Modally active motion commands (e.g. G0, G1, G2, G3)
Non-modally active motion commands, dwell time (e.g. G4, G74, G75)
Programmable offsets, working area limitations and pole programming (e.g.
TRANS, ROT, G25, G110)
Plane selection (e.g. G17, G18)
Machining the workpiece
7.12 Display G and auxiliary functions
181