Table of Contents
Advertisement
The IDE hard disk assembly kit includes the following:
IDE hard disk
4 screws
Plastic ribbon connector cables
Only one internal IDE hard disk is supported. However, you can add
up to three external SCSI hard disks to the printer.
»
Note: Before installing an internal IDE hard disk, you must have an
optional IDE-SCSI board.
If you are installing this optional board for the first time, refer now to
"IDE-SCSI Board," earlier in this section, for instructions. You will be
referred to these instructions at the appropriate time.
If the board is already installed, you must remove it before you can
install an internal hard disk. Refer to "Removing an IDE-SCSI Board,"
earlier in this chapter, for information on accessing the board.
Advertisement
Table of Contents
