Table of Contents
Advertisement
LUBRICATION
LUBRICATION
•
It is extremely important that the following lubrication schedule be followed: Bearings: use a good quality
multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using
grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines
and connections on grease banks for leaks.
•
Oilbath Oil: Use a good high quality universal oil. Use an oil that meets or exceeds hydraulic oil grade. Fill to a level
just above the lowest roller chain link in the oilbath. Change yearly or whenever contaminated.
•
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under a
no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize
heat-up during operation.
ITEM
1
2
3
4
5
6
OPERATION
REPLACEMENT PARTS
1
1
LUBRICATION
CAPACITY
INTERVAL
8 HOURS
8 HOURS
8 HOURS
50 HOURS
APPROX. 6.25 GALLONS
1000 HOURS
APPROX. 30 GALLONS
ANNUALLY
APPROX. 2 GALLONS
6
LUBRICATION
OIL TYPE
HIGH QUALITY MULTI PURPOSE GREASE
GOOD QUALITY HYDRAULIC OIL
ISO 46 HYDRAULIC OIL OR EQUIVALENT
DEXTRON III OIL
READ complete manual CAREFULLY
Page # 21
2
4
3
LOCATION
FRONT AUGER & REEL BEARINGS
REAR AUGER & REEL BEARINGS
DRIVELINE UNIVERSAL JOINTS
OIL BATH OIL (CHECK LEVEL)
REPLACE ANNUALLY
HYDRAULIC OIL (CHECK LEVEL)
REPLACE ANNUALLY
SLIDE TRAY POWER UNIT
BEFORE attempting operation.
Advertisement
Table of Contents
