Table of Contents
Advertisement
LUBRICATION
•
It is extremely important that the following lubrication schedule be followed: Bearings: use a good quality
multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using
grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines
and connections on grease banks for leaks.
•
Oilbath Oil: Use a high good quality universal oil. Use an oil that meets or exceeds hydraulic oil grade. Fill to the top
lower oilbath roller chains. Change yearly or whenever contaminated.
•
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under a
no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize
heat-up during operation.
ITEM
LUBRICATION
INTERVAL
1
8 HOURS
2
8 HOURS
3
8 HOURS
4
50 HOURS
5
ANNUALLY
6
ANNUALLY
LUBRICATION
CAPACITY
HIGH QUALITY MULTI PURPOSE GREASE
APPROX. 3.5 GALLONS
APPROX. 2 GALLONS
1.5 PINTS
Page # 21
OIL TYPE
GOOD QUALITY HYDRAULIC OIL
DEXTRON III OIL
80W90 GEARLUBE
LOCATION
FRONT AUGER & REEL BEARINGS
REAR AUGER & REEL BEARINGS
DRIVELINE UNIVERSAL JOINTS
OIL BATH OIL (CHECK LEVEL)
REPLACE ANNUALLY
SLIDE TRAY POWER UNIT
2:1 GEARBOX
Advertisement
Table of Contents
