Konica Minolta Magicolor 2300 DL Installation Manual page 26

The internal components of the print head
unit are NOT A FIELD SERVICEABLE
ITEM. Therefore, the print head unit should
not be opened under any circumstances.
Laser Caution For United States Users—CDRH Regulations
This printer is certified as a Class I laser product under the Regulation Performance Standard according to
the Food, Drug, and Cosmetic Act of 1990. Compliance is mandatory for laser products marketed in the
United States, and is reported to the Center for Devices and Radiological Health (CDRH) of the U.S. Food
and Drug Administration (FDA) of the Department of Health and Human Services (DHHS). This means that
the product does not produce hazardous laser radiation.The label shown below indicated compliance with
the CDRH regulations and must be attached to laser products marketed in the United States.
Laser Safety Label—CDRH Requirement
CAUTION:
Use of controls, adjustments, or performance other than those specified
in this manual may result in hazardous radiation exposure
This is a semiconductor laser. The maximum power of the laser diode is 5 mW, and the wavelength is
770–795 nm.
International Notices—Power Cord
The following power cord requirements are in effect for your 230 V printer.
2
Minimum: 0.75 mm
Minimum: H05 VV - F
The male plug is certified in the country in which the equipment is to be installed, and the female plug is an
IEC 60320 connector.
22
1 - Print head unit
2 - Laser aperture
1
2
.
Safety Information