Safety Information - Konica Minolta Magicolor 2300 DL Installation Manual

FCC Compliance Statement For American Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case, the user will be required to correct the interference at his
own expense.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device must be used with shielded interface cables. The use of non-shielded cable is likely to result in
interference with radio communications, and is prohibited under FCC rules.
Attention
Any modifications or changes to this product not expressly approved in writing
by the manufacturer responsible for compliance to Federal Regulations could
void the user's authority to operate this product within the Laws and
Regulations of the Federal Communications Commission.

Safety Information

Toner
Do not throw the toner cartridge or toner into an open flame. The hot toner may
scatter and cause burns or other damage.
CAUTION: Keep out of reach of children.
Laser Safety
This printer is a page printer which operates by means of a laser. There is no possibility of danger from the
laser, provided the printer is operated according to the instructions in this manual.
Since radiation emitted by the laser is completely confined within protective housings and external covers,
the laser beam cannot escape from the machine during any phase of user operation.
This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human
Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and
Safety Act of 1968. This means that the printer does not produce hazardous laser radiation.
Internal Laser Radiation
Maximum Average Radiant Power: 4.68 W at the surface of the OPC drum
Wavelength: 770–795 nm
This product employs a Class IIIb Laser Diode that has an invisible laser beam. The Laser Diode and
Scanning Polygon Mirror are incorporated in the print head unit. The print head is in the interior of the
printer in front of the toner cartridge. The laser beam is emitted from the print head unit, and then is
radiated through the laser aperture to the interior of the printer.
Safety Information
21