Step 11 Venting - Ancona IGCP430 User Manual And Installation Instructions

STEP 11
Venting
Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.
seal with certi ed aluminum or foil tape so that it is airtight. Please check the building codes in your city to learn which
tape product is recommended.
Connect ductwork to damper. Use Duct Tape to ensure joint is sealed and airtight.
IMPORTANT:
It is the customer's responsibility to contact a qualified electrical installer.
circuit, fused on both sides of the line.
IMPORTANT: Save this Installation Guide for electrical inspector's use.
GROUNDING INSTRUCTIONS:
shock by providing an escape wire for the electric current.
WARNING: Improper grounding can result in a risk of electric shock.
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/
CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-
connection kits that have been investigated and found acceptable for use with this model.
Installation
— 16 —