HAMPTON BAY Greenfire GCi60-2 Technical Manual page 14

m f i
aSonry ireplace
Rain Cap
Flexible stainless
steel pipe
connection
Figure 9: Masonry fireplace installation.
When installing the insert into a masonry fireplace, DO NOT remove any bricks or masonry, with the
following exception: masonry or steel, including the damper plate, may be removed from the smoke
shelf and adjacent damper frame, if necessary, to accommodate a chimney liner. Do this only if their
removal will not weaken the structure of the fireplace and chimney, and will not reduce protection for
combustible materials to less than that required by the national building code. When installing the
fireplace insert into a zero clearance fireplace, DO NOT cut or modify any factory firebox parts.
14
Installation Installation
:
nStallation
Steel Plate or Flashing
Flexible or Rigid 4"
Stainless Steel Liner
Masonry Fireplace
A
hearth pad (min. 24 gauge galvanized
steel or similar) must cover combustible
flooring underneath, as well as 6" (150
mm) in front of the heater and 6" (150
mm) to the side of the heater.
1. Install the hearth pad.
2. Lock any existing fireplace dampers
in the open position.
3. Set leveling leg to approximate
height.
Damper Removed
4. Connect a Exhaust Starter Quick
or Fastened Open
Connect straight to the exhaust pipe.
12" (30.5cm) Mantle
5. This fireplace insert must be installed
Minimum 36" (91 cm)
from Bottom of stove
with a continuous chimney liner
of 4" diameter extending from the
Surround Panel
fireplace insert to the top of the
chimney.
conform to the Class 3 requirements
of
Lining Systems for Existing Masonry
or Factory-Built Chimneys and Vents,
or
Lining Systems for New Masonry
Chimneys.
Min 6"
6. It is necessary to permanently seal
(150 mm)
any opening between the masonry of
Floor Protection
the fireplace and the facing masonry.
Combustible Floor
Hampton GCi60-2 Cast Pellet Insert Technical Manual
non-combustible manufactured
The chimney liner must
CAN/ULC-S635, Standard
CAN/ULC-S640, Standard
for
for