Table of Contents
Advertisement
insigniarange.com
Last Modified: 13/06/2017
Step 4
1
2
Now lock the front angled glass panel to the side glass panel by following
the position shown in the image marked "1"
Once you have met the back panel inside the front upright as per the close
up image walk the panel around to the position shown in the image
marked "2"
1
2
not
NOTE:
Do
apply silicone until Step 6
Step 4
1
Step 5
Silicone
specified as shown in diagram.
Next using the angled upright, place this to the rear squared glass panel by follow-
ing the position shown in the image marked "1"
2
Now move the angled upright in the direction as shown in image "1" until this is into
place as shown in image "2"
Once you are happy with the alignment then continue to screw the upright into
place at the top and bottom using ST14's
Step 5
Please note: These are not pilot holed and you will need to use the DB6
13
Advertisement
Table of Contents
