Table of Contents
Advertisement
insigniarange.com
Last Modified: 13/06/2017
Step 2
(please note, if your column has a rubber seal at the bottom , take the rubber off
and apply
silicone
inside the rubber and replace)
Step 2
Again,
Once you have completed a dry run
and are happy, Then continue to ap-
ply the silicone to the specified area of the control column and place next to the an-
gled back glass panel and fix together using the ST20 screws.
Step 3
Step 3
Apply
silicone
to the specified area's as shown and now fix
together and screw the large back glass panel to the column using the ST20 screws.
12
Advertisement
Table of Contents
