Table of Contents
Advertisement
o
F
PtionaL
inishing
The U37 comes equipped with clean finishing
edges installed to allow for facing materials like
stone and tile. An optional 3-piece set of finishing
edges is also supplied with an integrated finishing
clean edge flange to accommodate rough edge
facing materials like cement board and drywall (if
CSS has been activated). To install the optional
finishing edges:
1. Remove the safety screen (see M
a
s
- r
nD
erVIce
eMoVe
10).
2. Use a T-20 Screwdriver to remove the existing
clean finishing flanges. There are 6 screws per
side and 6 across the top to remove.
3. Install the supplied finishing flanges by re-
using the removed screws. The side flanges
are common and not left or right specific.
clean
edge
Initial Installation
QUALIFIED INSTALLERS ONLY
e
(
Dges
not aPPLicabLe FoR
aIntenance
s
s
on page
afety
creen
Figure 35: Finishing Edge Comparison
u37i-a):
Figure 34: Finishing Edge Removal/Installation
1/2" flange
21
Advertisement
Table of Contents
