Jp6A; Jp23 Green Led Mode Jumper; Jp30 Rom Sip; Cn1A - CHAINTECH 7VIL User Manual

JP6A (Enable/Disable USB 2/3 Device Power ON Jumper)
This motherboard is can be turned on by a USB keyboard hot key or a USB mouse
click. To use this function, select a hot key of your choice at the USB KB Power
Wake-up From S3 option under Wake Up Events in the BIOS's Power On
Management screen. You must also set this jumper's cap to pins 2-3 to use this
function.
JP23 (Green LED Mode Jumper):
This motherboard provides a Green LED flash Jumper. This cap is to setup Green
LED flash mode.
Chapter 2
Pin Definition
1-2 Disable (default)
2-3 Enable
Pin Definition
1-2 Normal (default)
2-3 Reserve
15
Chapter 2
JP30 (ROM SIP)
Pin Definition
1-2 Hardware (default)
2-3 Boot ROM
The ROM Serial Initialization Packet (SIP) function is for advanced user to use the
Boot ROM to boot up the system. For normal booting operation you must set the
jumper cap to pins 1-2 Hardware (default).
CN1A (Front Panel Connector):
1. PWR-SW (Over-ride Power Button Connector):
The power button on the ATX chassis can be used as a normal power switch as
well as a device to activate Advanced Power Management Suspend mode. This
mode is used for saving electricity when the computer is not in use for long periods
of time. The Soft-OFF by PWR-BTTN function in BIOS's Power Management
Setup menu must be set to [Delay 4 Sec.] to activate this function.
When the Soft-OFF by PWR-BTTN function is enabled, pushing the power button
16