Removing The Power Connector - Dell Latitude E6410 ATG Service Manual

Back to Removing and Replacing Parts
Power Connector
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Power Connector

NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in
2. Remove the
3. Remove the
4. Remove the Memory.
5. Remove the ExpressCard.
6. Remove the
7. Remove the
8. Remove the
9. Remove the
10. Remove the Latitude ON™ Flash/CMG module.
11. Remove the
12. Remove the
13. Remove the
14. Remove the
15. Remove the keyboard.
16. Remove the
17. Remove the
18. Remove the
19. Remove the
20. Remove the
21. Unthread the power source cable from the computer.
22. Lift up the power source port to remove from the computer.
Replacing the Power Connector
To replace the power connector, perform the above steps in reverse order.
Back to Removing and Replacing Parts
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Before Working Inside Your
ATG Port Cover (applicable on E6410 ATG computer only).
battery
optical drive.
hard drive.
hinge covers.
access panel.
WWAN card.
WLAN card.
coin-cell battery.
LED cover.
Fingerprint Reader.
Display Assembly.
ExpressCard cage.
palm rest.
system board.
UserManuals.info
Computer.