Removing The System Board; Replacing The System Board - Dell Latitude E6410 ATG Service Manual

Back to Removing and Replacing Parts
System Board
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the System Board

NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in
2. Remove the
3. Remove the battery.
4. Remove the
5. Remove the
6. Remove the ExpressCard.
7. Remove the
8. Remove the
9. Remove the
10. Remove the
11. Remove the
12. Remove the
13. Remove the keyboard.
14. Remove the
15. Remove the memory.
16. Remove the
17. Remove the
18. Remove the Latitude ON™ Flash/CMG module.
19. Remove the
20. Remove the
21. Remove the
22. Remove the
23. Disconnect the power connector from the system board.
24. Disconnect the smart card reader and IEEE 1394 cables from system board.
25. Remove the screws that secure the system board to the computer.
26. Starting in the back right corner and separate the system board from the I/O board connector.
27. Lift the back edge of the system board until all the connectors on the left side are separated and slide the system board towards the rear and remove
from the computer.

Replacing the System Board

To replace the system board, perform the above steps in reverse order.
Back to Removing and Replacing Parts
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Before Working Inside Your
ATG port cover (applicable on E6410 ATG computer only).
SIM card.
SD card.
Smart card.
hinge covers.
access panel.
optical drive.
hard drive.
LED cover.
coin-cell battery.
WWAN card.
WLAN card.
Fingerprint Reader.
Heat Sink and Processor Fan.
Display Assembly.
palm rest.
UserManuals.info
Computer.