a.
WLAN card
b.
I/O board connector
c.
memory module
d.
heat sink
e.
coin cell battery
f.
base cover
g.
optical drive
h.
keyboard
i.
battery
9. Follow the procedure in
Removing the power connector
1. Follow the procedure in
2. Remove the:
a.
battery
b.
optical drive
c.
keyboard
d.
base cover
e.
hard drive assembly
f.
optical drive
g.
WLAN card
h.
i/o board
i.
memory module
j.
coin cell battery
k.
heat sink
l.
system board
3. To remove the power connector:
a. Remove the black adhesive tape and unroute the power cable [1].
b. Remove the screw that secures the power connector to the computer [2].
c. Lift the power connector.
Installing the power connector
1. Insert the power connector into the slot on the computer.
2. Route the power connector cable through the routing channel.
28
Removing and installing components
After working inside your
Before working inside your
computer.
computer.