Advertisement
Mount sensor permanently and finish Fluke Connect process
1. AFTER connectivity with all sensors has been achieved, tap Continue and mount the sensors
permanently at the selected asset test points, as described in the mounting instructions.
2. AFTER mounting the sensors permanently, return to the Fluke Connect App to finalize the
permanent installation process.
9 Fluke Corporation
Fluke 3563 Sensor/ Gateway - Installation
Select sensor to install
1. All commissioned sensors appear in the Select Sensor to Install
screen. Select sensors to be installed, then tap Continue and
position the sensors at the designated test points.
Check gateway and sensor connection
1. From the Instructions screen that appears, tap
Continue to check whether the sensors are connected to the
gateway.
y On-screen hints show if connectivity between the gateway
and any sensor fails. If necessary, reposition the gateway.
y An additional gateway may be selected for installation by
tapping Add Gateways.
y The sensor connection check is not finalized until all
connection failures are resolved. Sensors that fail to connect
to the gateway must be removed.
Advertisement
