Advertisement
5 Fluke Corporation
Fluke 3563 Sensor/ Gateway - Installation
2. Click Add Group and edit the location name. If required, click
Add SubGroup and edit the name of the sublocation. See at
left.
3. Click Add Asset. The Asset name may be edited only in the
Asset Details editor, where other asset properties, including
speed, power, ID, and type of foundation, may also be edited.
See at left.
4. Use the Components editor to define the asset components.
See at left.
5. In the Test Points editor, click the Add test point tab at the
respective components, and then use the drop-down menus
to define the required test points:
y Test point name – edit name
y Position on the machine – define test point position
y Orientation – define sensor orientation at the test point
6. Use the Tasks & Alarms editor to configure the vibration
trends to be measured and the alarm limits to be set. You can
choose to apply recommended alarm limits that are based on
verified ISO standards and experience.
Detailed information about the different trend measurements
is available at the software online help, which is accessed by
clicking ? on the header.
7. Use the Device Settings editor to set the interval of the mea-
surement cycles (Overall Measurement interval) and data
transfer cycles (Overall Reporting interval). For detailed infor-
mation, refer to the LIVE-Asset™ Portal online help.
Advertisement
