Advertisement
Step 5
Position/install sensors and gateway
This section guides the user to physically mount gateways and sensors and should be
performed on-site.
Important: Temporarily position sensors and gateways as you complete all steps in this section
before you permanently mount the sensors or gateways. They may need to be repositioned.
8 Fluke Corporation
Fluke 3563 Sensor/ Gateway - Installation
Assign sensors to asset test points
1. Tap Assign on the Sensors screen. The asset hierarchy in the
Web-based software appears.
2. Assign the selected sensor to the desired asset test point.
3. Tap Save to complete the action.
NOTE: If no asset hierarchy has been configured within the
LIVE-Asset™ Portal, no asset hierarchy will appear when Assign
is selected
y On completion, the assigned sensor appears on the sen-
sor list with a breadcrumb showing the test point within
the hierarchy (e.g., Building 1>Wing A>Asset1>Driver
Component>Motor>Test Point1).
y To change or unassign a test point, tap the pencil icon (next
to the breadcrumb). This returns the user to the individual
asset screen.
Select gateway to install
1. From the Home screen, tap Gateways & Sensors in the Physical
Installation frame to select the gateway to be installed. All com-
missioned gateways appear under Available Gateways.
2. The following actions are available:
y Select an active gateway, tap Continue, and position at the
desired location.
y Select an inactive gateway, tap Connect to be guided
through the process of connecting the gateway to the cloud-
based Data Platform.
y Tap Skip to bypass the gateway installation and proceed
directly with sensor installation.
Advertisement
